Categories
4B 6B 8B

Safety mode – 8B/6B/4B

Under the glass cover there is a dip switch it’s job is to define the buttons mode (Using the included pin).
Disassemble the glass and continue by the instructions below.

Safe mode add the ability to select relays in panel to turn on after power outage.
Notice: You cannot config safe mode and momentary buttons in the same panel.

Output turn on after power outage.
To enable safety output, turn on dipswitch 10 and the desired outputs.
Notice:
Can’t set momentary and safety modes at the same panel.
Panels 6B/4B – dipswitches 4,5,6 are not valid.
Panels PT/2B – no dipswitches.
This setting not apply in panel 2R.